maggi200
Well-known member
Reposting this due to issues with images.
Required: Axle stands, Jack, deep 13mm socket, 4 x M12 spacers/washers 5mm thick
1) Jack the car up and get it on stands.
2) Remove the 3 rubber covers per side (the rear most inside bolt didn't have a cover on either side of my car).
I've only noted the outside ones, but the inside ones are directly in line with these either side of the exhaust. (I just can't see them in this picture to accurately note them)
3) Undo the 4 nuts per side with a deep 13mm socket.
You will end up with this
Required: Axle stands, Jack, deep 13mm socket, 4 x M12 spacers/washers 5mm thick
1) Jack the car up and get it on stands.
2) Remove the 3 rubber covers per side (the rear most inside bolt didn't have a cover on either side of my car).
I've only noted the outside ones, but the inside ones are directly in line with these either side of the exhaust. (I just can't see them in this picture to accurately note them)
3) Undo the 4 nuts per side with a deep 13mm socket.
You will end up with this