Recent content by Dsign

I need the pinouts from the ECU actually [email protected] Thank you

Hello Twingo 133 owners. Is there an engine wiring diagram for the 133 available somewhere around? Would be glad to have one. Thanks in advance

how much for the final drive kit?

As I spoke on Facebook, I managed to put on my 133 engine & gearbox on my Dacia Logan. I made a shortshifter system on my own. On the gearbox, the cables are attached on some balljoints. I took out the balljoints and welded them 1cm to the support of the linkage. The result is a shorter...

I have a home made short shifter system for my Tw133 gearbox, but since I haven't fitted my engine&gearbox on my Dacia, I cannot provide feedback on that. In December / January I'll finish the swap and come back here with feedback on shortshifter.

JR5 176 as far as I rmember

The shifting for the twingo is the same as for all the cable guided shifters from Renault. If you have in your offer something like that, you should only try it on a twingo. Might work.

The Twingo133 has JR5176 gearbox, with cable linkage, as said above. If somebody found a way to improve the shifting for these types of linkages, SPEAK now ! :D

I have the support for the alterntor, with a fake wheel insted of aircon. It comes from a CUP spec CNOR. I could change it for yours, I do need my aaircon in my car. By the way, I'm swapping my Dacia Logan 100bhp K4M with 133bhp K4m854. So the engine I bought came off a CUP spec. If you're...

Oh shoot! How could you do this? I only I was in England !!!

I think this picture comes from exactly the same fitting that I'm trying to sort out right now. So I have the following questions : - anyone knows the dimensions of the adapter (all of them)? - given the fact that 2 of the holes will be threaded (14mm), which material should I use? - anyone...

Hello dear friends Actually I own a Dacia Logan which has almost the same front suspension and brake setting as a non RS Twingo I got some Brembo calipers from a Megane 225/Clio 3 RS and now I'm trying to build some adapters. I have now the usual 259mm ventilated discs. Anyone knows someone...

Tip added to this guide : After completing with the whole process of fitting lower springs one may want to loosen all the rubber bushes from the front wishbones and from the rear axle, put the car onto an elevator on which the car will sit on the four wheels (as it normally sits on the street)...

Nice tip, learned from the Subaru service where I'm working right now : For the caliper pins is nice to use some pressure resistant grease, such as the blue one from Mobil1. (MOB VAZ XHP) The advantage is that it reduces to a minimum the chance of getting locked again and also it prevents the...

How much for the inlet manifold mate?